LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2019 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Image Display Camera System) >> Diagnostic Information And Procedures >> Rear Vision Camera System Malfunction >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify P17 Info Display Module displays infotainment system information properly.
    • Go to next step: If infotainment system information displays properly 
  3. Verify that DTC B2545 is not set.
    • Go to next step: If the DTC is not set 
  4. Verify the rearview camera there is no debris on the lens and that the bezel or bezel seal is not damaged.
    • If debris are found on the lens 

      Clean the lens using water and a soft cloth. If the lens, bezel, or bezel seal are damaged, replace as necessary.

    • Go to next step: If no debris on the lens 
  5. Engine running, parking brake applied, transmission in REVERSE.
  6. Verify the backup lamps are On.
    • Go to next step: If the backup lamps are ON 
  7. Engine running, parking brake applied, transmission in REVERSE.
  8. NOTE:

    A poor quality image is an image that has flickering, blinking, excessively blue/yellow hue, and/or fog/haze such that it obstructs the driver's view out the rear of the vehicle.

  9. Verify a clear rear vision image is displayed on the radio.
    • If a clear image is not displayed 

      Refer to Circuit/System Testing below.

    • Go to next step: If a clear image is displayed 
  10. All OK.