Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Operate the component: Left Rear Window Switch @ S79D Window Switch - Driver - Pressed & Pulled
Verify the scan tool parameter:
- Left Rear Window Main Control Down Switch = Inactive & Active
- Left Rear Window Main Control Express Switch = Inactive & Active
- Left Rear Window Main Control Up Switch = Inactive & Active
- If not the specified state
Replace the component: S79D Window Switch - Driver
- Go to next step: If the specified state
- Operate the component: Right Rear Window Switch @ S79D Window Switch - Driver - Pressed & Pulled
Verify the scan tool parameter:
- Right Rear Window Main Control Down Switch = Inactive & Active
- Right Rear Window Main Control Express Switch = Inactive & Active
- Right Rear Window Main Control Up Switch = Inactive & Active
- If not the specified state
Replace the component: S79D Window Switch - Driver
- Go to next step: If the specified state
- Operate the component: Right Front Window Switch @ S79D Window Switch - Driver - Pressed & Pulled
Verify the scan tool parameter:
- Front Passenger Window Main Control Down Switch = Inactive & Active
- Front Passenger Window Main Control Express Switch = Inactive & Active
- Front Passenger Window Main Control Up Switch = Inactive & Active
- If not the specified state
Replace the component: S79D Window Switch - Driver
- Go to next step: If the specified state
- Verify DTC B3205 4B is not set.
- If DTC B3205 4B is set
Use the following procedure: Window Motor Programming - Express Function .
- Go to next step: If the DTC is not set
- If DTC B3205 4B is set
- Operate the component: Driver Left Front Window Switch @ S79D Window Switch - Driver - Pressed & Pulled
Verify the component works as specified:
- M35D Window Motor Module - Driver = Up
- M35D Window Motor Module - Driver = Express Up
- M35D Window Motor Module - Driver = Down
- M35D Window Motor Module - Driver = Express Down
- If the component does not work as specified
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the component works as specified
- Verify DTC B3210 4B is not set.
- If DTC B3210 4B is set
Use the following procedure: Window Motor Programming - Express Function .
- Go to next step: If the DTC is not set
- If DTC B3210 4B is set
- Operate the component: S79P Window Switch - Passenger - Pressed & Pulled
Verify the component works as specified:
- M35P Window Motor Module - Passenger = Up
- M35P Window Motor Module - Passenger = Express Up
- M35P Window Motor Module - Passenger = Down
- M35P Window Motor Module - Passenger = Express Down
- If the component does not work as specified
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the component works as specified
- Operate the component: S79LR Window Switch - Left Rear - Pressed & Pulled
Verify the component works as specified:
- M74LR Window Motor - Left Rear = Up
- M74LR Window Motor - Left Rear = Down
- M74LR Window Motor - Left Rear = Express Down
- If the component does not work as specified
Refer to: Circuit/System Testing - Test 3
- Go to next step: If the component works as specified
- Operate the component: S79RR Window Switch - Right Rear - Pressed & Pulled
Verify the component works as specified:
- M74RR Window Motor - Right Rear = Up
- M74RR Window Motor - Right Rear = Down
- M74RR Window Motor - Right Rear = Express Down
- If the component does not work as specified
Refer to: Circuit/System Testing - Test 4
- Go to next step: If the component works as specified
- All OK.