Circuit/System Verification
WARNING: This page is about a different car, the 2018 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
- Verify there is no debris on the appropriate camera lens and that the bezel and bezel seal are not damaged.
- If debris is found on the lens
Clean the lens using water and a soft cloth. If the lens, bezel, or bezel seal are damaged, replace as necessary.
- Go to next step: If there is no debris on the lens
- If debris is found on the lens
- Engine running, transmission in R.
- Verify the backup lamps are illuminated.
- If the backup lamps are not illuminated
Refer to Backup Lamps Malfunction .
- Go to next step: If the backup lamps are illuminated
- If the backup lamps are not illuminated
- Engine running, transmission in R.
- Verify a clear rear vision image is displayed on the P17 info Display Module.
- If a clear rear vision image is not displayed
Refer to Rear Vision Camera System Malfunction (without UVH) Rear Vision Camera System Malfunction (with UVH) .
- Go to next step: If a clear rear vision image is displayed
- If a clear rear vision image is not displayed
- Engine running, transmission in D.
- If a clear image is not displayed on only one camera
Refer to Circuit/System Testing - Only one camera image distorted.
- If a clear image is not displayed for all cameras
Refer to Circuit/System Testing - All camera images distorted with IO3 OR All camera images distorted with IO5 or IO6
- Go to next step: If a clear image is displayed
- If a clear image is not displayed on only one camera
- All OK.
NOTE:
Inoperative or missing backup lamps may cause the surround vision rear view image to be displayed at all times.
NOTE:
A poor quality image is an image that has flickering, blinking, excessively blue/yellow hue, and/or fog/haze such that it obstructs the driver's view out the rear of the vehicle.