SD Card Setup

After a new SD Card has been installed, whether if be for the first time during new car prep or a replacement part for service, a series of on screen questions will need to be answered to properly setup the new SD Card. Failure to answer the questions correctly will result in the Navigation system being inoperative. Follow the steps below:

NOTE:

Do not remove the SD Card with the ignition ON as this could corrupt the SD Card and cause navigation related errors.

NOTE:

Do not swap SD Cards from vehicle to vehicle, SD Cards are VIN specific.

NOTE:

When inserting the SD card ensure the read/write switch on the side of the card is in the UP position (towards the contacts). Insert the card straight and not at an angle to ensure the card does not rub on the side of the slot changing the position on the switch. If the switch is in the incorrect (down) position unexpected messages and a loss of navigation features may occur.

1. Ignition OFF
2. Remove the old SD Card from the X83 Auxiliary Audio Input SD Card slot if needed, insert the new SD Card into the slot making sure it is fully seated.
3. Ignition ON, infotainment system ON.
4. The first screen to appear will read, Access and Input Data Permissions. Select Show Permissions
5. The next 4 screens will ask for certain access and permission. Select ALLOW on all screens.
   NOTE:

   If DENY is selected on any screen the Navigation system will be inoperative.

6. If successful, the last screen will display a Navigation Map.