LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2020 >> XT6 Sport >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K172 Night Vision Control Module: Programming And Setup >> Replace and Program Control Module or Reprogram Control Module - With Night Vision Camera Replacement
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Replace and Program Control Module or Reprogram Control Module - With Night Vision Camera Replacement

NOTE:

Reprogram the Night Vision Camera Control Module when the Night Vision Camera is replaced. If the same camera has been removed and installed, perform Night Vision Control Module Learn .

To program a replacement or an existing control module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. On the SPS Supported Controllers screen, select K172 Night Vision Camera Control Module - Programming and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K172 Night Vision Camera Control Module - Setup to enable Night Vision Calibration. Refer to Night Vision Control Module Learn .
  4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
scientia non olet · About LEMON Manuals