Adding Transmitters (Without SPS)
WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- To initiate, this procedure requires that 2 learned transmitters be available.
- A total of eight transmitters can be learned to a single vehicle.
- This procedure adds transmitters only. The procedure does not erase previously learned transmitters.
- Place the recognized transmitters in the vehicle cupholder.
- Insert the vehicle key into the key cylinder located next to the door handle under the lock cylinder cap and turn the key to the unlock position five times within ten seconds. The driver information center will display Remote Learn Pending, Please Wait.
- Place the new transmitter into the transmitter pocket.
- Press and release the ignition mode switch. When the transmitter is learned, the driver information center will indicate that it is ready to program the next transmitter.
- Remove the transmitter from the transmitter pocket and press the transmitter unlock button. To program additional transmitters, repeat Steps 3 through 5.
- When all additional transmitters are programmed, press and hold the ignition mode switch for 15 seconds to exit programming mode.
NOTE:
For the transmitter pocket location refer to the Remote Keyless Entry (RKE) System Operation document in the owner's manual.