LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2023 >> LYRIQ Debut Edition >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> K124 Image Processing Module: Programming and Setup (with UKL) >> Replace and Program Image Processing Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replace and Program Image Processing Module

NOTE:

Due to continuous improvements, the on screen selections may vary from instructions below.

Upon replacement of the K124 Image Processing Module, perform the following procedures:

  1. Install the EL-49642 SPS  Programming Support Tool to maintain system voltage.
  2. Ensure the programming tool is equipped with the latest software and is securely connected to the data link connector. If there is an interruption during programming, programming failure or control module damage may occur.
  3. Ignition/Vehicle OFF.
  4. Access the Service Programming System (SPS) and follow the on-screen instructions.
  5. On the SPS Supported Controllers screen, select K124 Image Processing Module - Programming and follow the on-screen instructions.
  6. Perform Serial Data Authentication Configuration. Serial Data Authentication Configuration 
  7. Perform Vehicle Dynamic Sensor Offset Calibration. Vehicle Dynamic Sensor Offset Calibration
  8. Perform All Cameras Alignment Learn. Surround Vision Camera Calibration (cameras wired to K124 Image Processing Module)
scientia non olet · About LEMON Manuals