LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2023 >> LYRIQ Debut Edition >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> K124 Image Processing Module: Programming and Setup (with UKL) >> Reprogram Image Processing Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reprogram Image Processing Module

NOTE:

DO NOT reprogram a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct calibration software, the control module will not control all of the vehicle features properly.

NOTE:

Due to continuous improvements, the on screen selections may vary from instructions below.

To reprogram an existing K124 Image Processing Module, perform the following procedure:

  1. Install the EL-49642 SPS  Programming Support Tool to maintain system voltage.
  2. Ensure the programming tool is equipped with the latest software and is securely connected to the data link connector. If there is an interruption during programming, programming failure or control module damage may occur.
  3. Ignition/Vehicle OFF.
  4. Access the Service Programming System (SPS) and follow the on-screen instructions.
  5. On the SPS Supported Controllers screen, select K124 Image Processing Module - Programming and follow the on-screen instructions.
  6. Clear DTCs.
scientia non olet · About LEMON Manuals