Common Specs & Procedures Index
COMMON SPECS & PROCEDURES
| SYSTEM | SPECIFICATION/PROCEDURE | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | Approximate Fluid Capacities | ||
| Torque | Fastener Specifications | ||
| Wheel Drive Shaft Nut | |||
| Front or Rear | First Pass: 150 N.m (111 lb ft) Second Pass: Loosen 45 Degrees Final Pass: 250 N.m (185 lb ft) |
||
| Battery | Battery Electrical Drain/Parasitic Load Test | ||
| Brakes | |||
| Bleeding Sequence | LEFT REAR, LEFT FRONT, RIGHT FRONT, RIGHT REAR See Hydraulic Brake System Bleeding |
||
| Disc Brakes | |||
| Service Specifications | Disc Brake Component Specifications | ||
| Torque | Fastener Specifications | ||
| Charging | |||
| Generator | Charging System Test | ||
| Torque | Fastener Specifications | ||
| Drive Belts | |||
| Adjustment | Non-Adjustable Serpentine Belt | ||
| Drive Belt Routing | See the Figure Under Accessory Drive Primary Belt Replacement | ||
| Engine Cooling | |||
| General Service Specifications | Specifications | ||
| Radiator Cap Pressure | Radiator Surge Tank Cap Testing | ||
| Thermostat R & I | Engine Coolant Flow Control Valve Replacement (LSY) | ||
| Water Pump R & I | Electric Engine Coolant Pump Replacement | ||
| Engine Mechanical | |||
| Compression | Engine Compression Test | ||
| Oil Pressure | @ 1500 RPM 100°C - 199.95 kPa (29 psi) | ||
| Overhaul | Engine Mechanical Specifications | ||
| Torque | Fastener Specifications | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flexplate Bolt Torque | First Pass: 20 N.m (15 lb ft) Second Pass: 70 degrees |
||
| Fuel System | |||
| Fuel Pressure Test Procedure | Circuit/System Verification | ||
| Fuel Filter Location | Fuel Filter is Part of the Fuel Tank Fuel Pump Module | ||
| Fuel Filter R & I | Fuel Tank Fuel Pump Module Replacement (AWD) or Fuel Tank Fuel Pump Module Replacement (FWD) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | Firing Order & Cylinder Identification | ||
| Ignition Wires (Resistance) | Individual Ignition Coil/Module Assemblies | ||
| Ignition Wires (Routing) | Coil On Plug | ||
| Spark Plug - For application, see parts catalog. | |||
| Gap | 0.70 - 0.80 mm (0.028 - 0.031 in) | ||
| Torque | 17 N.m (13 lb ft) | ||
| Starting | |||
| Starter | Starter Replacement (LSY - FWD)
or Starter Replacement (LSY - AWD) |
||
| Torque | Fastener Specifications | ||
| Wheel Alignment | |||
| Adjustment Specifications | Wheel Alignment Specifications | ||
| Torque | Fastener Specifications | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 190 N.m (140 ft lb) For Lug Nut Tightening Sequence, Please See the Figure Under Installation Procedure |
||