K68 Trailer Lighting Control Module: Scan Tool Information

Trailer Interface Control Module Scan Tool Data Parameters

Parameter	System State	Expected Value	Description
Operating Conditions: Ignition ON
Battery Voltage	-	Varies 12 - 14 V	The scan tool displays volts. This is the voltage of the trailer lighting converter.
Brake Pedal Switch Status	-	Inactive/Active	The scan tool displays Active when the brake pedal is pressed. The scan tool displays Inactive when the brake pedal is released.
Run/Crank Terminal Status	-	Inactive/Active	The scan tool displays Active when the Run/Crank output terminal is active. The scan tool displays Inactive when the Run/Crank output terminal is inactive.
Trailer Connection Detected	-	No/Yes	The scan tool displays Yes if a trailer is connected to the vehicle or the rear carrier system is installed. The scan tool displays No if no trailer is connected to the vehicle or the rear carrier system is not installed.
Trailer Detection	-	Enabled/Disabled	The scan tool displays Enabled if the automatic trailer detection as active or Disabled if not active.
Vehicle Identification Number	-	varies	The scan tool displays Vehicle Identification Number.

Trailer Interface Control Module Scan Tool Output Controls

Output Control	Description
Left Trailer Tail Lamp Command	Commands the left trailer tail lamp ON and OFF.
Right Trailer Tail Lamp Command	Commands the right trailer tail lamp ON and OFF.
Left Trailer Turn Signal Lamp Command	Commands the left trailer turn signal lamp ON and OFF.
Right Trailer Turn Signal Lamp Command	Commands the right trailer turn signal lamp ON and OFF.
Trailer Brake Lamps	Commands the trailer brake lamps ON and OFF.
Trailer Backup Lamps	Commands the trailer backup lamps ON and OFF.
Trailer Fog Lamp(s)	Commands the trailer fog lamp(s) ON and OFF.
CAN Bus Configuration Learn	This command activates the CAN Bus configuration learn procedure.