Wiper Will Not Delay Between Wipes Dash Switch In Delay Mode
- With ignition "ON" and dash switch in mid-delay position, remove connector from No. 6 and 7 terminals, then reinstall connector so it misses No. 6 terminal. If wiper still will not delay, see step 2) . If wiper operates correctly, check for grounded wire between No. 6 terminal and dash switch. If no ground is apparent, replace dash switch.
- Remove washer pump cover and reinstall wiring. With ignition "ON" and dash switch in mid-delay position, disconnect Yellow wire from pulse relay. If wiper will not delay, replace pulse relay. If wiper fails to operate, replace timing device.