Riding Height Checking
- Place vehicle on smooth level surface. Bounce vehicle several times. Raise vehicle and allow to settle at normal height. Measure distance as shown in Fig 1 and Fig 2.
NOTE: Height check should be made with a full tank of gas, spare tire installed, and jack included. No passengers should be in vehicle.
- Difference between measurements of each side must not be more than 1/2". If an adjustment is necessary, it can be made at bolt on height control arm.
RIDING HEIGHT SPECIFICATIONS
| Application | Front | Rear | |
|---|---|---|---|
| LUV 2 Wheel Drive | |||
| Standard | 4.6" (116.8 mm) | 6.1" (155 mm) | |
| Long Wheelbase | 4.6" (116.8 mm) | 7.5" (190 mm) | |
| LUV 4 x 4 | 4.8" (122 mm) | 7.7" (195 mm) | |