LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1988 >> Camaro Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition System - Direct >> Removal & Installation >> Ignition Module >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

  1. Disconnect negative battery cable. Unplug connectors at ignition module. Disconnect spark plug wires from coil pack. Remove ignition module from engine block. Remove coils and assembly plate. To install, reverse removal procedures.
NOTE: If spark plug boots adhere to spark plugs, use Boot Remover (J-36011). Twist first and then pull upward. Boots must be in place on housing prior to ignition system assembly installation or damage may result.
scientia non olet · About LEMON Manuals