Throttle Position Sensor (TPS) Replacement

Throttle Position Sensor (TPS):

REMOVE OR DISCONNECT:
1. TPS electrical connector.
2. Using a #25 torx bit remove two TPS attaching screws and retainers.
3. TPS sensor.


INSTALL OR CONNECT:
1. With the throttle valve in the normally closed idle position, install throttle position sensor on throttle body assembly, making sure TPS pickup lever lines up with tang on throttle actuator lever.
2. Two TPS screws and tighten to 2.0 N-m (18.0 in lbs).