Manifold Pressure/Vacuum Sensor: Service and Repair

MAP Sensor:

REMOVE OR DISCONNECT
1. Manifold Absolute Pressure (MAP) sensor electrical connector.
2. Attaching screws.
3. MAP sensor.

INSTALL OR CONNECT

1. Position seal (lubricated with a very thin film of clean engine oil) into manifold assembly halfway, insert MAP sensor nipple into seal, seat sensor fully into seal and onto mounting surface.
2. MAP sensor screws.

Tighten
MAP sensor screws to 3 Nm (27 lb in). DO NOT OVER TORQUE.

3. Electrical connector.