Crankshaft Position Sensor: Service and Repair

Ignition Coil Assembly And CKP Sensor:

REMOVE OR DISCONNECT
1. Sensor harness connector at module.
2. Sensor to block bolt (1).
3. Sensor from engine.

INSPECT

^ Sensor 0-ring for wear, cracks or leakage. Replace if necessary. Lube new 0-ring with engine oil before installing.

INSTALL OR CONNECT
1. Sensor into hole in block.
2. Sensor to block bolt (1).

^ Torque to 8 Nm (71 lb in).

3. Sensor harness connector at module.