Only Rear Door Lock Function Does Not Operate (Cargo Doors)
- Disconnect RKE control module connector C2. Hold either power door lock switch in LOCK position. Connect fused jumper wire between RKE control module connector C2 terminal "B" (Tan wire) and ground. Keep jumper wire connected for remainder of test. If rear power door lock motor does not lock, go to next step. If rear power door lock motor locks, replace RKE control module.
- Disconnect rear door lock motor connector. Connect test light between connector terminal "A" (Gray wire) and ground. Hold either power door lock switch in LOCK position. If test light comes on, go to next step. If test light does not come on, repair open circuit in Gray wire.
- Connect test light between rear door lock motor terminals "B" (Tan wire) and "A" (Gray wire). Hold either power door lock switch in LOCK position. If test light comes on, replace rear door lock motor. If test light does not light, repair open circuit in Tan wire.