Instrument Panel Fuse Block Replacement

The instrument panel fuse block is part of the instrument panel wire harness. To replace the fuse block the entire wiring harness needs to be replaced.

Remove or Disconnect
1. Bolt/screw (86) connecting fuse block to carrier (75).
2. Instrument panel fuse block.

Install or Connect

NOTICE: Refer to Service Precautions / Vehicle Damage Warnings / Fastener Requirements.

1. Instrument panel fuse block to carrier (75).
2. Bolt/screw (86).

Tighten
^ Instrument panel fuse block bolt/screw (86) to 1.5 Nm (13 lb. in).