Adjustment Using New Park/Neutral Position Switch

Adjust
1. Place transmission control (805) in "NEUTRAL."
2. Tang (818) on park/neutral position switch (817) into slot on transmission control (805).
3. Park/neutral position switch screws (819) to transmission control (805).

Tighten
- Park/neutral position switch screws (819) to 2.2 Nm (19 lb in).

Important:
- If the park/neutral position switch screw holes will not align with the transmission control, verify the transmission control is in the "NEUTRAL" position. Do not rotate the park/neutral position switch. If the switch has been rotated and the pin is broken, the switch can be adjusted using the procedure under "ADJUSTMENT USING OLD PARK/NEUTRAL POSITION SWITCH."

4. Front floor console.
5. Negative battery cable.

Tighten
- Negative battery cable to 15 Nm (11 lb ft).