HVAC System - Manual

REMOVAL PROCEDURE




1. Remove the I/P accessory trim plate.
2. Remove the retaining screws from the HVAC control assembly.
3. Pull the assembly out from the instrument panel.




4. Disconnect the electrical and vacuum connectors.
5. Remove the HVAC control assembly.

INSTALLATION PROCEDURE




1. Connect the electrical and vacuum connectors to the HVAC control assembly.




2. Install the HVAC control assembly into the instrument panel by snapping into place.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the retaining screws to secure the HVAC control assembly.

Tighten
Tighten the fasteners to 1.8 N.m (16 lb in).

4. Install the I/P accessory trim plate.