Fuel Tank Pressure Sensor: Service and Repair

REMOVAL PROCEDURE
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure. Service and Repair
2. Drain fuel tank. Refer to Fuel Tank Draining Procedure. Procedures
3. Raise the vehicle. Go to Lifting and Jacking the Vehicle in General Information.
4. Remove the fuel tank.
5. Remove the electrical connector from the fuel tank pressure sensor.
6. Remove the fuel tank pressure sensor (10) from the modular fuel sender.

INSTALLATION PROCEDURE
1. Install the new fuel tank pressure sensor (10) to the modular fuel sender.
2. Connect the electrical connector to the fuel tank pressure sensor.
3. Reinstall the fuel tank.
4. Refill the fuel tank.
5. Reconnect the negative battery cable.
6. Inspect for fuel leaks.
6.1. Turn ON the ignition for 2 seconds.
6.2. Turn OFF the ignition for 10 seconds.
6.3. Turn ON the ignition.
6.4. Check for fuel leaks.