Generator Bracket Replacement

REMOVAL PROCEDURE
1. Remove generator rear brace.
2. Remove the fuel rail from the upper intake manifold.






3. Remove the generator brace bracket bolts.
4. Remove the generator bracket from the cylinder head.

INSTALLATION PROCEDURE
1. Install the generator bracket to the cylinder head.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the generator brace bracket bolts.

Tighten
Tighten the generator brace bracket bolts to 50 N.m (37 lb ft).

3. Install the fuel rail to the upper intake manifold.
4. Install the generator rear brace.