V5 - Direct Mount
REMOVAL PROCEDURETOOLS REQUIRED
J 41790 Compressor Holding Fixture
1. Install the compressor onto the J 41790.
2. Remove the compressor control valve retaining ring using internal snap ring pliers.
3. Remove the compressor control valve from the compressor.
INSTALLATION PROCEDURE
TOOLS REQUIRED
J 41790 Compressor Holding Fixture
1. Coat the control valve O-Rings with clean 525 viscosity refrigeration oil.
2. Push the compressor control valve into the compressor with thumb pressure.
3. Using internal snap ring pliers, install the compressor control valve retaining ring. Ensure that the retaining ring is properly seated in the ring groove.
4. Remove the compressor from the J 41790.