Techline Terminal to Vehicle (No Tech 2)

1. Using a Tech 2, select New BCM Setup and program the BCM with the correct RPO code configuration.
2. Enter the Service Programming System (SPS) using a Techline Terminal (T-50/T-60).
3. Select terminal to vehicle programming.
4. Select Done.
5. Follow the instructions on the Vehicle Set-up screen.
6. Select the Vehicle Theft Re-learn option.
7. Follow the instructions on the remaining screens.
8. Attempt to start the engine. If the engine does not start, Refer to the A Powertrain On Board Diagnostic (OBD) System Check

IMPORTANT: Performing this procedure may cause a DTC P1630 to set. If a DTC P1630 sets, turn OFF the ignition for 30 seconds, then turn ON the ignition. If the DTC P1630 does not clear, Refer to A Powertrain On Board Diagnostic (OBD) System Check.