Ignition Coil: Service and Repair

REMOVAL PROCEDURE




1. Turn OFF the ignition
2. Note position of spark plug wires for installation and disconnect the spark plug wires from ignition coils (2).




3. Remove the 2 screws (1) securing ignition coil (2) to ignition control module (3).
4. Remove the ignition coil (2).

INSTALLATION PROCEDURE




1. Install the ignition coil (2) on the ignition control module (3).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Reinstall the 2 attaching screws (1).

Tighten
Tighten the screws to 4.5 N.m (40 lb in).




3. Connect the spark plug wires as noted during removal.