Generator Brace Replacement

REMOVAL PROCEDURE






1. Loosen the generator pivot bolt (1).
2. Remove the generator rear brace nut (4).
3. Remove the generator rear brace.

INSTALLATION PROCEDURE






1. Install the generator rear brace.
2. Install the generator pivot bolt (1) finger tight.
3. Install the generator rear brace nut (4) finger tight.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Tighten the generator bolt and nut as described:

Tighten
4.1. Tighten the generator pivot bolt (1) to 50 N.m (37 lb ft).
4.2. Tighten the generator rear brace nut (4) to 25 N.m (18 lb ft).