LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2000 >> Impala V6-3.8L VIN K >> Repair and Diagnosis >> Power and Ground Distribution >> Fuse Block >> Service and Repair >> Relay/Fuse Center Replacement (Right)
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Relay/Fuse Center Replacement (Right)

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the RH instrument panel (IP) fuse block access opening cover.
3. Remove the IP compartment.
4. Disconnect the body wiring harness from the junction block.




5. Remove the junction block bolt.
6. Disengage the junction block tabs from the passenger knee bolster. Pull the junction block away from the IP.
7. Disconnect the wiring harnesses from the junction block.
8. Remove the junction block.

INSTALLATION PROCEDURE




1. Connect the body wiring harnesses to the junction block.

Tighten
Tighten the body wiring harness connector bolts to 7 N.m (62 lb in).

2. Install the junction block tabs to the passenger knee bolster.
3. Install the junction block bolt.

Tighten
Tighten the junction block bolt to 10 N.m (89 lb in).




4. Connect the body wiring harness to the junction block.
5. Install the instrument panel (IP) compartment.
6. Install the RH IP fuse block access opening cover.
7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals