Ignition Coil: Service and Repair

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Disconnect the spark plug wires (note position that the wires are removed).
3. Remove 2 screws (1) securing the coil (2) to the ignition control module (3).
4. Remove the coil (1).

INSTALLATION PROCEDURE
1. Attach the coil assembly to the ignition control module.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install two attaching screws (1).

Tighten
Tighten the screws to 4-5 N.m (40 lb in).

3. Connect the spark plug wires.