Ignition Coil: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the ignition coil electrical connector.
2. Remove the ignition coil retaining bolt (1).
3. Pull up in order to remove the ignition coil (2).

INSTALLATION PROCEDURE
1. Install ignition coil (2) into the valve cover.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Secure the ignition coil to the engine with the retaining bolt (1).

Tighten
Tighten the retaining bolt to 10 N.m (89 lb ft).

3. Connect the ignition coil electrical connector.