On-Board Diagnostics: Notes

Powertrain Control Module (PCM) is equipped with a self-diagnostic system which detects system failures or abnormalities. When a malfunction occurs, PCM will store a Diagnostic Trouble Code (DTC) and, in most cases, illuminate the Malfunction Indicator Light (MIL) located on instrument cluster. Malfunctions are recorded as hard failures or intermittent failures.

Most hard failures cause MIL to illuminate and remain on until malfunction is repaired. If MIL illuminates and remains on (light may flash) during vehicle operation, cause of malfunction must be determined. See DIAGNOSTIC PROCEDURE .

If a sensor fails, PCM may use a substitute value in its calculations to continue engine operation. In this condition, vehicle is functional, but will most likely display degraded driveability.

Intermittent failures may cause MIL to flicker or glow and turn off about 10 seconds after intermittent fault goes away. Corresponding DTC, however, will be retained in PCM memory. Intermittent failures may be caused by sensor, connector or wiring related problems. See INTERMITTENTS in appropriate TROUBLE SHOOTING - NO CODES article.