Remote Control Door Lock Receiver: Removal

Disconnect negative battery cable.
Remove 2 bolts (3) which secure instrument panel driver's side knee bolster trim (1). Position trim as necessary to gain access to instrument panel driver's side knee bolster reinforcement. See Fig 1 .
Remove 2 bolts which secure reinforcement and lower knee bolster reinforcement (1). See Fig 2 .
Remove plastic retainer (1) and left instrument panel outer air outlet duct (2). See Fig 3 .
Remove screw (2) which secures junction block No. 2 (1) and position aside in order to gain necessary clearance to remove left instrument panel outer air outlet. See Fig 4 .
Remove screw and left instrument panel outer air outlet (1). See Fig 5 .
Disconnect remote control door lock receiver electrical connector.
Remove Remote Control Door Lock (RCLDR) retaining nut and RCDLR (1) with mounting bracket attached. See Fig 6 .
Depress retaining tab and remove mounting bracket from RCDLR, if necessary.

Fig 1: Removing Knee Bolster Trim

Courtesy of GENERAL MOTORS CORP.

Fig 2: Identifying Knee Bolster

Courtesy of GENERAL MOTORS CORP.

Fig 3: Identifying Outer Air Outlet Duct

Courtesy of GENERAL MOTORS CORP.

Fig 4: Removing Junction Block No. 2

Courtesy of GENERAL MOTORS CORP.

Fig 5: Identifying Left Outer Air Outlet

Courtesy of GENERAL MOTORS CORP.

Fig 6: Locating Remote Control Door Lock Receiver

Courtesy of GENERAL MOTORS CORP.