LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2001 >> Venture LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 748 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ball stud to the rear axle tie rod.

    Tighten 

    Tighten the height sensor ball stud to 4 N.m (35 lb in).

  2. Install the automatic level control sensor link to the tie rod ball stud.
  3. Lower the vehicle.
  4. Install the ELC/TRAILER fuse.
    Fig 1: Installing Ball Stud To Rear Axle Tie Rod
    G01483357Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals