LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Lighting Systems) >> Repair Instructions >> Hazard Warning Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hazard Warning Switch
    GM519460Courtesy of GENERAL MOTORS CORP.
  1. Install the hazard warning switch to the I/P cluster trim plate.
  2. Connect the electrical connector to the hazard warning switch.
    3. Fig 2: Access Covers At I/P Fuse Block
    GM813479Courtesy of GENERAL MOTORS CORP.
  3. Press the I/P cluster trim plate into the I/P trim pad, until all of the retainers are fully seated.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the I/P cluster trim plate screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. For the Monte Carlo, install the left access cover to the I/P fuse block.

    For the Impala, install the right and the left access covers to the I/P fuse block.

  6. Install the steering column filler. Refer to Steering Column Filler Replacement in Instrument Panel, Gages, and Console.
  7. For the Monte Carlo, close the I/P compartment door.
    8. Fig 3: Ignition Lock Cylinder Bezel
    GM601131Courtesy of GENERAL MOTORS CORP.
  8. Reposition the steering wheel to the original position.
  9. If the vehicle is equipped with column shift, position the transaxle shift control indicator to Park.
  10. Install the bezel to the ignition lock cylinder.
  11. Release the parking brake.
scientia non olet · About LEMON Manuals