Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Tracker. However, it is still accessible from the selected car via links, so may be relevant.

Install the remote control door lock receiver (2) to the mounting bracket (3). Secure the receiver with 2 screws (1).

Fig 1: Two Screws & Remote Control Door Lock Receiver
Courtesy of GENERAL MOTORS CORP.
Connect the receiver electrical connector (3).
Install the 2 retainers (2, 4) which secure the remote control door lock receiver electrical connector (3).

Fig 2: Connecting Receiver Electrical Connector
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Reposition the receiver bracket (2) back to its original position. Secure the receiver bracket with the retaining nut (1).
Tighten
1. Tighten the remote control door lock receiver bracket nut to 10 N.m (89 lb in).
Reprogram the remote control door lock receiver. Refer to TRANSMITTER PROGRAMMING .

Fig 3: Installing Nut Which Secures Remote Control Door Lock Receiver Bracket
Courtesy of GENERAL MOTORS CORP.