Installation Procedure
Courtesy of GENERAL MOTORS CORP.
- Using a grease pencil, mark the antenna location on the front windshield 2 mm (0.079 in) down from the black-out area and 30 mm (1.18 in) from the side black-out area.
- Prepare the interior glass using an isopropyl alcohol pad and a clean lint-free cloth.
- Remove the backing paper from the antenna housing and begin removing the backing on the metallic strip.
- Install the GPS antenna onto the windshield at the marked location.
- Pull down gently on the headliner for best adhesion of the GPS antenna and grounding tab.
- Remove the backing from the metallic strip and adhere the GPS antenna to the roof.
- Connect the GPS antenna coaxial cable to the VIU.
- Route the GPS antenna coaxial cable through the IP and up the left front A-pillar.
- Tape the GPS antenna coaxial cable to the OnStar® harness.
- Install the IP trim pad. Refer to TRIM PAD REPLACEMENT - IP UPPER
.
- Install the garnish molding to the left front windshield. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILL
.
- Install the left front sunshade. Refer to SUNSHADE REPLACEMENT
.
Courtesy of GENERAL MOTORS CORP.