LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Venture Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 1363 (Antilock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hub and bearing assembly (2) to the vehicle. Refer to WHEEL BEARING/HUB REPLACEMENT - FRONT  in Front Suspension.
    Fig 1: Installing Hub And Bearing Assembly
    G01483734Courtesy of GENERAL MOTORS CORP.
  2. Install the front wheel speed sensor jumper harness electrical connector (1) to front wheel speed sensor connector (3).
  3. Install the wheel and tire assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  in Tires and Wheels.
  4. Lower the vehicle.
  5. Turn the ignition switch to the RUN position with the engine off.
  6. Perform Diagnostic system check. Refer to DIAGNOSTIC SYSTEM CHECK - ABS   . 
    Fig 2: Installing Front Wheel Speed Sensor Jumper Harness Electrical Connector To Front Wheel Speed Sensor Connector
    G01483735Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals