Installation Procedure

Slide the module (3) into the mounting bracket (1).
Push the module (3) towards the mounting bracket (1) at the end near the tab (2).
Push until the module (3) is seated in the mounting bracket (1).

Fig 1: Installing Module Into Mounting Bracket
Courtesy of GENERAL MOTORS CORP.
Install the module and bracket (2) to the I/P.
CAUTION: Refer to FASTENER NOTICE .
Install the bolts (3).
Tighten

Tighten the bolts (3) to 3 N.m (27 lb in).
Connect the coaxial cable and the electrical connectors (2) to the module.
Install the drivers knee bolster. Refer to KNEE BOLSTER REPLACEMENT - LEFT .

Fig 2: Installing Module & Bracket Assembly
Courtesy of GENERAL MOTORS CORP.