LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> S10 Pickup 2D Pickup, 2.2 H, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls Self-Diagnostics - 2.2L >> Drive Cycles >> Inspection/Maintenance Heated Oxygen Sensor System Set Procedure >> Test Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

The numbers below refer to the step numbers on the diagnostic procedures.

  1. 1 -  Make sure you perform the I/M System Check before performing this test. Failure to do so may result in difficulty updating the status to YES.
  2. 2 -  Preprogramming the scan tool will reduce the amount of time the oxygen sensor heaters operate while verifying the enable criteria.
  3. 3 -  This step is to identify a first failure of a type "B" DTC. A DTC only appears on the I/M System Status display when the DTC becomes a MIL illuminating DTC. This occurs on the second failure of a type "B" DTC. A first failure of a type "B" DTC will not allow the I/M System Status to update to YES. Refer to DIAGNOSTIC AIDS  .
  4. 4 -  This step is to identify a first failure of a type "B" DTC. A DTC only appears on the I/M System Status display when the DTC becomes a MIL illuminating DTC. This occurs on the second failure of a type "B" DTC. A first failure of a type "B" DTC will not allow the I/M System Status to update to YES. Refer to DIAGNOSTIC AIDS  .
  5. 5 -  The I/M System Status only reports on whether or not a diagnostic has run, not what the outcome of the test was. If any emission related DTC sets after the tests are complete, the DTC will require diagnosis.

scientia non olet · About LEMON Manuals