Installation Procedure

Install the guide adjuster bracket to the pillar.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the 2 guide adjuster bracket retaining bolts to the pillar.
Tighten: Tighten the guide adjuster bracket retaining bolts to the pillar to 20 N.m (15 lb ft).

Fig 1: Locating Guide Adjuster Bracket Retaining Bolts
Courtesy of GENERAL MOTORS CORP.
Align the tabs of the C-pillar side garnish molding trim with the openings in the pillar and push inward until fully seated.
Install the shoulder belt retaining bolt to the guide adjuster bracket.
Tighten: Tighten the shoulder belt retaining bolt to the guide adjuster bracket to 53 N.m (39 lb ft).
Close the cover on the rear seat shoulder belt bolt.