Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The ribbon must not be twisted.

Fig 1: View of Cruise Control Cable Slug to Ribbon Buckle

Courtesy of GENERAL MOTORS CORP.

Connect the cruise control cable slug to the ribbon buckle.

Fig 2: Aligning Cruise Control Cable

Courtesy of GENERAL MOTORS CORP.

Insert the cruise control cable into the cruise control module until the seal touches the module.
Position the narrow cable tab into the narrow slot and the wide tab into the wide slot.

IMPORTANT: The adjuster tab must be pointing toward the front of the car after installation.

Connect the cruise control cable to the cruise control module by turning the cable clockwise.
Install the cruise control cable to the retainer clip on the engine.
Install the cruise control cable to the throttle body bracket pressing into place until fully seated.

Fig 3: View of Cruise Control Cable

Courtesy of GENERAL MOTORS CORP.

Open the throttle body cam slightly.
Connect the cruise control cable to the throttle body cam lever.