Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
- Position the radio to the I/P.
- Connect the I/P wiring harness connectors and the antenna cable connector to the radio.
- Align the radio locator tab to the I/P locator opening. Install the radio.
- Install the radio screws.
Tighten: Tighten the radio screws to 2 N.m (18 lb in).
- Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (Pontiac) or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile) in Instrument Panel, Gages and Console.
- Perform the radio set up procedure for new and reinstalled radios. Refer to Radio Setup .
IMPORTANT:
If the radio locator tab is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.
NOTE:
Refer to Fastener Notice in Cautions and Notices.