Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
- To install the digital radio receiver bracket, perform the following steps:
- Align the bracket to the I/P reinforcement (1).
- Install the bracket bolts (4).
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Install the I/P fuse block. Verify that the retainer is engaged. Refer to Instrument Panel Electrical Center or Junction Block Replacement in Wiring Systems.
- Install the I/P outer trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement in Instrument Panel, Gages, and Console.
NOTE: Refer to Fastener Notice in Cautions and Notices. - Connect the antenna cable to the digital radio receiver.
- Connect the I/P wiring harness connector to the receiver. Install the CPA.
- Align the receiver to the bracket.
- Install the digital radio receiver nuts.
Tighten: Tighten the nuts to 6 N.m (53 lb in).
- Install the right side outboard I/P insulator. Refer to Closeout/Insulator Panel Replacement - Right (Outboard) or Closeout/Insulator Panel Replacement - Right (Inboard) in Instrument Panel, Gages, and Console.
- Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
- Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .