Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Savana and 2004 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Ignition Control Module

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ignition control module (2) and the heat sink (1) on the bracket with the screws (4).
Tighten: Tighten the screws to 3.5 N.m (31 lb in).
Reconnect the electrical connectors (3).
Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.