LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Bracket Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the BPMV and EBCM assembly (2) to the BPMV mounting bracket (4).
  2. Install the BPMV bracket (4) to the strut tower.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 1 bolt and 3 nuts that attach the BPMV mounting bracket (4) to the strut tower.

    Tighten: 

    • Tighten the lower 2 BPMV mounting bracket nuts (3) and bolt to 10 N.m (89 lb in).
    • Tighten the top nut (1) for BPMV mounting bracket (4) to strut tower to 3 N.m (27 lb in).

  4. Reconnect the ground strap between the EBCM assembly and the chassis.
  5. Turn the ignition switch to the RUN position, engine off.
  6. Perform the Diagnostic System Check - ABS .
    7. Fig 1: Installing BPMV Mounting Bracket
    GM394422Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals