LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the power steering pump and reposition. Refer to Power Steering Pump Replacement (3.4L) or Power Steering Pump Replacement (3.8L) in Power Steering System.
  2. Disconnect the camshaft position (CMP) sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
  5. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
    6. Fig 1: Removing CMP Sensor
    GM16120Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals