Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Headlamp Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Connect the electrical connector (2).
Install the screws (1) securing the switch to the trim panel.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: Using Flat Tool to Release I/P Retaining Clips

Courtesy of GENERAL MOTORS CORP.

Install the left knee bolster trim. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages, and Console.