Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

From underneath the vehicle, slide the license lamp onto the rear fascia.

Fig 1: View of License Lamp Assembly Fasteners

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

While holding the license lamp in place, install the license lamp screws.
Tighten: Tighten the license lamp assembly screws to 2 N.m (18 lb in).

Fig 2: View of License Lamp Socket

Courtesy of GENERAL MOTORS CORP.

Install the license lamp socket into the license lamp assembly.
Rotate the license lamp socket clockwise to engage the locking tabs.