LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System - 2.5L (LE8) (Introduction) >> Repair Instructions >> Accelerator Controls Cable Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the accelerator control cable (1) to the cable bracket.
  2. Rotate the throttle lever (1) to the WOT position.
  3. Insert the accelerator control cable end into the throttle lever slot (2).
  4. Install the accelerator control cable (1) into the bracket and secure with the cable locknut (3) and the cable adjusting nut (2). Do not tighten fully.
    5. Fig 1: View Of Throttle Lever & Throttle Lever Slot
    GM720512Courtesy of GENERAL MOTORS CORP.
  5. Push the accelerator control cable through the bulkhead grommet.
  6. Connect the accelerator control cable (1) to the accelerator pedal (2).
  7. Adjust the accelerator control cable end play and the accelerator pedal free play. Refer to Accelerator Cable Adjustment .
    8. Fig 2: View Of Accelerator Pedal & Control Cable
    GM158305Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals