Installation Procedure
- Connect the electrical/audio and antenna cable connectors to the radio.
- Install the radio into the I/P center support bracket.
Align the radio locator tab into the I/P center support bracket locator hole.
- Install the bolts/screws to the radio.
Tighten: Tighten the bolts/screws to 2.5 N.m (22 lb in).
- Install the instrument panel accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.
- Perform the radio set up procedure. Refer to Radio Setup .
NOTE:
Refer to Fastener Notice in Cautions and Notices.