LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 409 (Theft Deterrent System) >> Repair Instructions >> Theft Deterrent Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel (IP) knee bolster. Refer to KNEE BOLSTER REPLACEMENT .
  2. Remove the ignition lock cylinder. Refer to IGNITION LOCK CYLINDER REPLACEMENT -- ON VEHICLE (CYLINDER ROTATES) or IGNITION LOCK CYLINDER REPLACEMENT -- ON VEHICLE (UNABLE TO ROTATE CYLINDER) .
  3. Remove the upper steering column shroud.
  4. Disconnect the electrical connector at the base of the steering column.
  5. Pull the PASS-Key* III module from the ignition lock cylinder housing.
    Fig 1: Disconnecting Electrical Connector At Base Of Steering Column
    G01813549Courtesy of GENERAL MOTORS CORP.
  6. Remove the electrical connector and wires from the steering column.
  7. Remove the PASS-Key* III module from the vehicle.
scientia non olet · About LEMON Manuals